1.
When does the GPS logic assume a procedure turn in conjunction with an approach?
A.
When the IAF and FAF are the same (until established on final
approach course)
B.
When the IAF and FAF are the same
C.
When the IAF and FAF are not the same (until established on final approach course)
2.
The IAF and FAF are NOT the same. You crossed the IAF inbound. The OBS light was off, and the GPS has sequenced you to the next waypoint, but you want to hold back at the IAF. How do you re-select and enable the approach again?
A.
Suspend sequencing then re-enable the approach by selecting "Unload Approach" then press ENTER
B.
Suspend sequencing then re-enable the approach by selecting "Change Approach" then press ENTER
C.
Suspend sequencing then re-enable the approach by selecting "Suspend Approach" then press ENTER
3.
On final approach course and you’re 2.5 miles from FAF and there is no blinking green light, what does it mean?
A.
the approach is not active
B.
RAIM prediction has failed
C.
either a. or b.
4.
What keystrokes do you use to re-enable an approach? (IAF and FAF are NOT the same)
A.
SEL - Small Knob right one click - Enter - Enter
B.
SEL - Small Knob left one click - Enter - Enter
C.
SEL - Small Knob left two clicks - Enter - Enter
5.
When does the OBS HLD light illuminate in conjunction with GPS Approaches?
A.
after pressing DIRECT-ENTER-ENTER.
B.
crossing the FAF inbound, when pressing DIRECT, DIRECT until established on final.
C.
When you load an approach (IAF/FAF the same) until established on final; crossing FAF inbound; when beginning the missed approach procedure (after pressing GPS SEQ); and, when pressing DIRECT, DIRECT until established on final.
This is the end of the test. When you have completed all the questions and reviewed your answers, press the button below to grade the test.